INCANDESCENT FAA L-864
1 / 2Páginas

Point Flashing Beacon PFB INCANDESCENT FAA L-864 Compliances: Registered ISO 9001:2008 ETL Verified FAA L-864 to FAA Advisory Circular 150/5345-43G ICAO Annex 14 Medium Intensity Types B & C The PFB-EX incandescent red flashing 300mm beacon is specified for use on aviation obstructions. All exterior metal beacon parts are powdercoat painted aviation yellow for corrosion resistance that meets the US Military Standard Salt Fog Test conducted per MIL-STD-810F, Method 509.4, Procedure I. The PFB-EX beacon requires an external POC series custom controller to flash and operate as specified. Lamps & Voltage — 700: 700 watts, 120 volts 620: 620 watts, 120 volts 702: 700 watts, 230 volts FAA certified with FAA lamp number 48B FS: Flare Stack (see next page) MT: Marine Treatment EX: Explosion-Proof (see OL211PFB) Input Power: Power: Cable: Temp Rating: Mounting: Replacement Parts Lamp Life: Height: Diameter: Weight: The incandescent red beacon shall comply with FAA L-864 and ICAO medium intensity Type B. All hardware shall be stainless steel including the tie rods. All exterior aluminum cast beacon parts shall be powdercoat painted aviation yellow for corrosion resistance that meets the US Military Standard Salt Fog Test conducted per MIL-STD-810F, Method 509.4, Procedure I. The lenses shall be separated using properly sized gaskets and metal Z-rings. The beacon shall be prewired with a 3-conductor #14 AWG cable and the portion inside the beacon shall be heat protected with fiberglass sleeving. Internal wiring shall be high temperature rated and fiberglass insulated. The system of red lenses shall be Fresnel type of tempered glass manufactured by Kopp Glass. The lenses shall be certified to meet the chromaticity requirements of U.S. military specification MIL-C-25050.

Point Flashing Beacon PFB INCANDESCENT FAA L-864 option: - FS Flare Stack Application No electronics, plastic or other temperature sensitive materials shall be used in the beacon manufacture. High temperature rated materials shall be used. All internal wiring shall be high temperature rated and fiberglass sleeve insulation shall also be added to fully cover all wiring. The external wiring cable loop shall be high temperature rated. PL40139 Heat Shield: Optional Shield for use with option - FS The heat shield shall be installed suspended in the air space between the flare stack metal surface...