BT200
2Pages

New and Improved! The BT200 follows in the footsteps of the BT100 - the most popular Beacon Tester in the world! The BT200 has improved measurement accuracies, is inherently rugged, and is intuitive to use. Now completely integrated, this tester packs a whole lot of measurement capability into a very small package. AIS measurements have been added to the extensive list of features. Use this instrument for your entire beacon testing needs: code verification, annual certifications, inspections, and even for troubleshooting! Test all 406 EPIRBs and PLBs, ELTs, and AIS-EPIRBs. Perform beacon testing and inspections without using expensive equipment. FEATURES INCLUDE • scalable to meet your requirements -EPIRB/PLB or add ELT, AIS, and LimitTester measurement capabilities • compact, rugged device with integrated receiver • familiar Android operating system • device is IP68 rated - waterproof and very rugged! • receives all Cospas-Sarsat frequency channels and protocols • measures RF parameters and modulation details • powerful 406 MHz graphic measurements for power, phase modulation and in-band spectrum • internal antenna receives 406 burst from very close to 10 meters away or connect beacon directly to tester at 50Q • no attenuator required • add text comments, audio, photos or videos to each measurement • user-defined cable loss factor • easy to use file system • creates PDF Test Report • creates delimited text log file - for easy data extraction and analysis • easily interface to PC via cable, wifi, or USB drive • each unit includes a Certificate of Calibration with detailed calibration data • free software and firmware updates online • outstanding customer support • Cospas-Sarsat Second Generation Beacon (SGB) ready Comply with FAA Part 91.207, CAR 571 Appendix G, and CAA Euro CAE requirements for ELT certifications and MSC Circ. 1039 and 1040 for EPIRB Certifications. Make sure the beacons you are testing are operating properly by testing them thoroughly!

Miscellaneous Parameters Ordering options ... Start with the base configuration ... BT200 - the basic version will decode all 406 EPIRBs and PLBs, and measure all 406 MHz and 121.5 MHz signal parameters. Then choose your options ... add ELT: Adds the additional capability to decode all ELTs and measure the 243 MHz channel. add AIS: AIS (Rx) OR AIS (Rx & Tx) Adds the additional capability to decode and measure the AIS channel in AIS-EPIRBs (Rx only) or GMDSS (Rx & Tx) add LimitTester: Adds the LimitTester function to see at a glance if the beacon has passed or failed. Ordering codes...