DESCRIPTION application features Series V14500 valves are applicable to all commonly used non-corrosive fluids and gases. They are widely used in many current aircraft fuel systems. Military Specifications MIL-F-8615 and MIL-V-8610 are applicable to these valves. Series V14500 are direct acting, solenoid shut-off valves with inline porting. they are 2-way valves which seal tight, with flow and/or pressure possible in either direction. the flow path is straight through type rather than circuitous. Series 14500 valves are extremely reliable because their simple construction employs only two moving parts. they are lightweight and compact. Valve shut-off is accomplished by use of Valcor’s “Floating Seal” principle. this utilizes an optically flat seal disc against an equally flat seat. the gate-type action actually wipes the seat clean with each valve operation and virtually keeps the valve from being affected by contaminants. • 2-way Shut-Off • Gate-Type Design • Floating Seal • 1/2” O.D. Line • Configurations: Normally Closed, Normally Open • Temperature: -65°F to +165°F (Standard Static Seals), -65°F to +450°F (Special Static Seals) • Pressure range: 0-1000 PSIG Maximum • Proof pressure: 1500 PSIG • Burst pressure: 3000 PSIG Minimum • Weight: 1.25 lbs (approx.) © 2017 VALCOR ENGINEERING CORPORATION PH:973-467-8400 FX:973-467-9592 WWW.VALCOR.COM

SOLENOID VALVE SERIES V14500 Specifications Operating Pressure and Flow Ratings NORMALLY CLOSED CONFIGURATION Equiv. Sharp Edged Orifice CD = .65 Ambient Temp. Operating Pressure (PSIG) These ratings are based on using JP4 Aviation Fuel. Other orifice sizes, both larger and smaller, are available. However, ratings would change accordingly. For higher temperatures, the pressure rating must be reduced. The following table approximates the derating required. Temperature Derating Factor Electrical Data Voltage Duty 18 to 30 VDC 19 OHM Coil, Continuous or Intermittent 30 OHM Coil, Continuous (Depends...