Catalogs >
VAISALA OYJ >
VaiNet Wireless Access Point AP10

VaiNet Wireless Access Point AP10
2Pages

Catalog excerpts

VaiNet Wireless Access Point AP10 Features • One AP10 supports up to 32 VaiNet data loggers • Powered by Power over Ethernet (PoE) or DC adapter • Minimal infrastructure and no signal amplifiers needed • Uses HTTPS communication and encryption to ensure secure data transmission • Chirp Spread Spectrum wireless modulation is resistant to multipath fading • Secure firewall and tamper-proof data backup AP10 in the viewLinc Monitoring System AP10 access point transfers measurement data from wireless VaiNet data loggers to the viewLinc Enterprise Server, and enables the remote configuration and management of VaiNet data loggers by the viewLinc administrator. A wired Ethernet network connection between AP10 and viewLinc Enterprise Server is required. Registration of new data loggers is handled by viewLinc Enterprise Server software. Whenever a new data logger is added to the system, AP10 automatically identifies it and forwards its information to viewLinc. Once accepted in viewLinc, VaiNet data loggers stay synchronized, even in situations where other nearby VaiNet networks overlap. Data Integrity Data is encrypted during VaiNet transfers to protect against eavesdropping, data tampering, and transfer errors. Both the access point and the viewLinc Enterprise Server software verify that the data has been received correctly. Once the data is verified, it is stored to viewLinc's secure database and protected from tampering and loss. Redundancy Redundancy of the wireless connection is achieved through use of multiple VaiNet access points and free connection capacity in the system. If a VaiNet data logger has a connection problem, it will automatically connect to another available access point in the system. At least two access points with free capacity are needed for failover to function. Time Synchronization AP10 requires accurate time to operate its VaiNet wireless connection, and to maintain correct time on the connected data loggers. To achieve the accurate time, AP10 synchronizes with Network Time Protocol (NTP) servers. AP10 synchronizes with default NTP servers over the internet. To allow AP10 to operate without an internet connection, configure it to use your local NTP server.

Open the catalog to page 1

Inputs and Outputs Vaisala VaiNet LoRa™ chirp spread spectrum modulation 14 dBm (25 mW) Non-removable external antenna At least 100 m (328 ft) 8 868 MHz (Europe and Singapore) 915 MHz (North America, China, Australia, and New Zealand) EN/UL/IEC 61010-1 KDB 447498 (United States) RSS-102 Issue 5 (Canada) EN/IEC 61326-1, industrial environment ETSI EN 300 220-2 EN 301 489-1 EN 301 489-3 FCC title 47 part 15.247 (FCC ID: 2AO39-AP10A) ICE RSS-247 (IC: 23830-AP10A) AS/NZS 4268 Networking standards Modulation Output power Antenna Typical range (indoors) Maximum number of access points in an area...

Open the catalog to page 2

VaiNet Wireless Access Point AP10 2Pages

Catalog excerpts

All VAISALA OYJ catalogs and technical brochures

VaiNet Wireless Access Point AP10
2Pages