SPEC SHEET SIZE OF SPINNER REQUIRED ___________ MAKE AND SIZE OF ENGINE -----------------MAKE OF PROPELLER *________________ NUMBER OF BLADES ______________ BOLT PATTTERN 75mm ___ 100MM___ RTX 4” ___ SAE 1 ___ SAE 2 ___ SIZE OF BOLTS 1/4”___ 8mm____ 5/16”___ 3/8”____ 7/16’___ 1/2”___ * If Warp Drive, please specify: Standard _____ * if IVO, Please specify if it is : ground adjustable____ in flight adj. _____ FOR WARP DRIVE, GSC, IVO, AND POWER FIN, WE HAVE TEMPLATES ON HAND TO SEND YOUR SPINNER WITH THE BLADE OPENINGS PRE-CUT, READY FOR INSTALLATION. FOR MOST OTHERS, WE SEND THE SPINNER OUT ASSEMBLED, BALANCED,WITH THE BLADE OPENINGS TO BE CUT BY THE CUSTOMER. FULL INSTRUCTIONS FOR DOING THIS SIMPLE TASK ARE ENCLOSED WITH THE SPINNER. HOWEVER, WE DO NEED SOME ADDITIONAL INFORMATION. BLADES IN RELATION TO THE BOLT PATERN: WOULD A CENTER- LINE FROM TIP TO TIP OF THE PROP PASS THROUGH THE BOLTS (“A”) OR BETWEEN THE BOLTS (“B”) THICKNESS OF THE HUB______ WIDTH OF THE BLADES AT THE POINT THEY WILL EXIT THE SPINNER _______ (THESE MEASURMENTS DETERMINE THE BOLT SPACING FOR THE DOME ATTACHMENT BOLTS) IF YOU HAVE A LARGER THAN “NORMAL” GAP FROM THE PROP FLANGE TO THE COWL FRONT - FROM THE FRONT OF THE FLANGE TO THE FRONT OF THE COWL IS _________ INCHES. QUESTIONS? GET IN TOUCH WITH US! PHONE: 519 550-1311 E-MAIL: SPINNERS@EXECULI