CXOQ/CXOQHG OSCILLATOR 1 6 kHz to 100 MHz Surface Mount Quartz Crystal Oscillator DESCRIPTION Ultra-miniature, high performance quartz crystal oscillator designed and manufactured for high-reliability applications. FEATURES ■ 2.5 x 2.0 mm hermetically sealed ceramic package ■ High shock resistance (HG version) up to 75,000 g ■ Low acceleration sensitivity ■ Low power consumption ■ Fast start-up time ■ Full military testing available IBIS model available ■ Designed and manufactured in the USA APPLICATIONS Medical ■ Test & Diagnostic Equipment ■ Handheld Devices ■ Patient Monitoring Devices Defense and Aerospace ■ Communications ■ Navigation ■ GPS Industrial ■ Miniature Clock Requirements ■ Handheld Instrumentation ■ Transponder/Animal Migration 1. Output Enable/Disable (E) or no connection (N) PACKAGING OPTIONS SUGGESTED LAND PATTERN ■ Tape and Reel (per EIA 481). See Tape and Reel datasheet 10109. STATEK CORPORATION 512 N. MAIN ST., ORANGE, CA 92868 714-639-7810 FAX: 714-997-1256 www.statek.com

Specifications are typical at 25°C unless otherwise noted. Specifications are subject to change without notice. Tighter specifications available. *When PIN 1 is allowed to float, it is held high by an internal pull-up resistor. ENABLE/DISABLE OPTIONS (E/N) Statek offers two enable/disable options: E and N. The E-version has a Tri-state output and stops oscillating internally when the output is put into the high Z state. The N-version does not have PIN 1 connected internally and so has no enable/disable capability. The following table describes the Enable/Disable option E. STATEK CORPORATION 512...

Typical Phase Noise (dBc/Hz) (3.3 V) 1. Upper integration frequency point is clock frequency dependent. Period Jitter (Typical) 10,000 cycles (3.3 V) Special Blank = Standard S = Special or Custom HOW TO ORDER CXOQ/CXOQHG OSCILLATORS CXOQ HG High Shock HG = High Shock Blank = Standard Enable/Disable Option E = Enable/Disable N = No Connection Frequency Stability over Temp. Range (in ppm) Operating Temp. Range C = -10OC to +70OC I = -40OC to +85OC M = -55OC to +1 25OC S = Customer Specified Shock Level Code Blank = 5,000 g Terminations Blank = Gold Plated (Lead Free) SM3 = Solder (60/40 Sn-Pb)...