L115Technical Datasheet Aluminium Plate Service. Quality. Value. • Aerospace Components • Defence Components • High Technology Applications A medium strength rolled plate, solution heat-treated, artificially aged and stress relieved arriving at the 'T651' condition. Officially, the scope of the specification covers only thicknesses between 6 and 25mm. Of these, only 12 to 25mm thick are ultrasonically tested. However, ultrasonically tested metal up to at least 127mm thick is commonly made to chemical composition only, although mechanical properties are usually achieved as well. General Engineering Equivalent - 6082T651 BS EN Euronorm - EN 573 / 754 Controlled Stretched AECMA Euronorm - BE EN 4202 Anodising Protective - Good Bright - Fair Hard - Good / Very Good Colour - Good Plating & Vitreous Enamelling Special pre-treatment necessary to achieve successful results Brazing & Soldering - Good Inert Gas -Very Good Resistance, Spot, Beam - Very Good Very Good For further assistance please contact our Sales Dept / Laboratory. Resistance to Atmospheric Attack - Good Cut Size to Size Sawn Blanks Cut To Length and Width + / -1.6mm All information in our data sheet is based on approximate testing and is stated to the best of our knowledge and belief. It is presented apart from contractual obligations and does not constitute any guarantee of properties or of processing or application possibilities in individual cases. Our warranties and liabilities are stated exclusively in our terms of trading. © Smiths Metal Centres 2017