Technical Data Sheet AeroShell Oil W80 Plus Mineral ashless dispersant oil for aircraft piston engines. AeroShell Oil W80 Plus is a single grade oil that combines the single grade, ashless dispersant performance found in AeroShell Oil W80 and the anti-wear/anti-corrosion additives of AeroShell Oil W 15W-50 Multigrade. It is the oil for pilots who prefer a single grade but who also want the extra protection and performance. • Blended from selected high viscosity mineral base oils. • Contains AeroShell's proven W Oils additive package. • Additional anti-wear additives (containing Lycoming additive LW 16702 equivalent). • Additional anti-corrosion additives. • Fully compatible with other approved aircraft piston engine oils. • The advanced additives in AeroShell Oil W80 Plus provide better rust and wear protection than conventional single grades. The additives work as a protective barrier to prevent critical parts from being slowly degraded by rust or wear, especially when an aircraft sits idle. This protection helps keep the camshaft and lifters coated, reducing the likelihood of premature damage and helping operators reach TBO. • AeroShell Oil W80 Plus already contains, in the correct proportions, an anti-wear additive equivalent to the Lycoming additive LW 16702; thus complying with FAA Airworthiness Directive 80-04-03 R2 p.1b. Operators who use AeroShell Oil W80 Plus DO NOT need to add this Lycoming additive to the oil. • AeroShell Oil W80 Plus is qualified for use in all Continental Motors liquid cooled and air cooled aircraft piston engines. • Textron Lycoming: 301F, Service Bulletins 446E and 471B, Service Instruction 1409C For a full listing of equipment approvals and recommendations, please consult your local Shell Technical Helpdesk.

These characteristics are typical of current production. Whilst future production will conform to Shell's specification, variations in these characteristics may occur. This product is unlikely to present any significant health or safety hazard when properly used in the recommended application and good standards of personal hygiene are maintained. Avoid contact with skin. Use impervious gloves with used oil. After skin contact, wash immediately with soap and water. Guidance on Health and Safety is available on the appropriate Safety Data Sheet, which can be obtained from https://www.epc.shell.com...