Introduction
ALLEN® 2020L is a high impact ABS sheet known for its excellent forming properties and medium gloss finish. It is suitable for various applications including marine products, recreational vehicles, and equipment covers.

General Information
The product has achieved a UL94 HB rating at 0.060 inches (1.52mm) and complies with Federal Motor Vehicle Safety Standard No. 302 (FMVSS 302).

Suggested Applications

• Marine products
• Recreational vehicles
• Agricultural cab interiors
• Truck interiors
• Equipment covers
• P.O.P displays
• Film laminations

Features

• Good forming and fabricating properties
• Edge trim easily used in future orders
• Medium gloss finish

Environmental and Safety Considerations
SEKISUI SPI emphasizes safe handling, manufacturing, and disposal of its products. For more information, contact their Technical Service department or visit their website.

Physical Properties
The document provides typical values for various physical, mechanical, and thermal properties, including:

• Specific Gravity: 1.02-1.05 g/cc
• Gloss (60° Angle): 80%
• Tensile Strength: 5,100 psi (35.1 MPa)
• Flexural Modulus: 370,000 psi (2,551.0 MPa)
• Flexural Strength: 11,300 psi (77.9 MPa)
• Notch Izod Impact at 73°F: 8.0 ft-lb/in (427 J/m)
• Notch Izod Impact at 0°F: 2.7 ft-lb/in (144 J/m)
• Heat Deflection Temperature (HDT) at 66 psi: 195°F (90.6°C)
• Mold Shrinkage: 0.004-0.007 in/in

Flammability
The product has been tested under laboratory conditions and meets UL 94HB criteria. However, SEKISUI SPI does not guarantee these results in the final product configuration.

Disclaimer
SEKISUI SPI provides this information without warranty of merchantability or fitness for a particular use. Users should conduct their own tests to determine product suitability for specific applications.