DIGITAL LASER DISTANCE METER The Digital Laser Distance Meter RIEGL LD05e-A30-PH67 is a successor of the LD90-31K-HiP with an IP67-specified housing. State-of-the-art digital signal processing enables precise distance measurement for complex multi-target situations even under bad visibility conditions. Digitizing the echo signal and subsequent analyzing allows multitarget distance measurements. Four target distances can be detected and provided for each laser shot. The LD05e-A30-PH67 is especially designed for the use without reflectors. It offers extremely “High Penetration”-capabilities under conditions of bad visibility and is therefore ideally suited for long-range applications in ship-docking systems and for laser altimetry, etc. Its High Penetration Mode allows for acquisition of highly accurate and reliable data in complex target situations, based on a sequence of laser shots and a self-adapting (rather low) data update rate. Additionally, pre detection-averaging allows significant enhancement of the maximum range. Short infrared laser pulses providing excellent interference immunity Narrow measurement beam with low divergence for excellent spatial resolution Measurement to almost any surface regardless of the angle of incidence of the beam and the surface characteristics Stable aluminium housing, ready to be used in harsh industrial environments. Different pre-configured measurement modes, but also individually programmable for customer specific applications

Technical Data LD05e-A30-PH67Performance ExamplesThe following pre-configured High Penetration Modes with different measuring times are available. Measurement Program 0, measuring time 0.3 secl 1) The following conditions are assumed • target is larger than footprint of laser beam • perpendicular angle of incidence • visibility 10 km • typical values for average ambient brightness conditions. In bright sunlight, the operational range is considerably shorter than under an overcast sky. At dawn or at night the range is even higher. 2) Reflecting foil 3M DG4090 or equivalent, dimensions > 0.45 x...

Technical Data LD05e-A30-PH67 Measurement Program 2, measuring time 1 seci 1) The following conditions are assumed • target is larger than footprint of laser beam • perpendicular angle of incidence • visibility 10 km • typical values for average ambient brightness conditions. In bright sunlight, the operational range is considerably shorter than under an overcast sky. At dawn or at night the range is even higher. 2) Reflecting foil 3M DG4090 or equivalent, dimensions > 0.45 x 0.45 m2. 3) Minimum distance 5 m for full accuracy with retro-reflecting targets. 4) One sigma standard deviation @ 50...

Technical Data LD05e-A30-PH67Laser Specifications Wavelength 1) Measured at the 1/e2 points.lmrad corresponds to 10 cm beam width per 100 m distance. 1) The life expectancy (MTBF) of the instrument is reduced in case of operation and/or storage at high temperatures. Data Sheet RIEGL LD05e-A30-PH67, 2021-06-15 page 4 of 5

Technical Data LD05e-A30-PH67 Dimensional Drawings Copyright RIEGL Laser Measurement Systems GmbH © 2021 – All rights reserved. Use of this data sheet other than for personal purposes requires RIEGL’s written consent. This data sheet is compiled with care. However, errors cannot be fully excluded and alternations might be necessary. Data Sheet RIEGL LD05e-A30-PH67, 2021-06-15, page 5 of 5 RIEGL Laser Measurement Systems GmbH, 3580 Horn, Austria Tel.: +43-2982-4211, E-mail: [email protected], www.riegl.com RIEGL USA Inc., E-mail: [email protected], www.rieglusa.com RIEGL Japan Ltd., E-mail: [email protected],...