Aerospace Energy Measurement Railway Sensorex® High performance MEMS accelerometer, single & twin axis Model SX40000 Characteristics • Range: ±0.25g, ±1g • USB 2.0, 2 wires RS485 Modbus RTU, 4-20mA • Specially designed for severe environments (shocks, vibrations, electromagnetic perturbations) • Very long term stability • High performances • Conform to: EMI 50121-3-2 V2006/ EN 61326-1 V2013 • Linear acceleration/ deceleration measurements • Automatic train position control (ATC, ATP, ERTMS) • Tilting train • Low frequency vibration measurements (seismic monitoring) MEGGiTT smart engineering for extreme environments Meggitt (Sensorex) selected the best MEMS cells available on the market and associated them to the digital signal compensation and processing stage to obtain an accelerometer that matches the key performances of servo-accelerometers, at an optimized cost. - Maximum non linearity: <0.05% de PE - Resolution < 0.01mg Power supply can span from +4.5 to +30VDC. This unit is available in different ranges, ±0.25g & ±1g. Signals (directly proportional to the acceleration) are made available to the end-user as 4-20mA, RS485 and USB outputs. Specifically designed to operate in stringent vibratory environments, one of the key parameters of our MEMS accelerometer is its adjustable bandwidth between 0.01Hz and 10Hz (thanks to a configurable digital filter). A complete auto test is automatically made at the start of the sensor and results are transmitted to the digital outputs and to the open drain output BIT-OUT. Our measurement product competencies: LVDTs | Inertial systems | Inclinometers | Accelerometers | IMU | MEMS sensors | Servo-inclinometer | Conditione

Aerospace Energy Measurement Railway Mechanical characteristics Dimensions Housing material Product identification Sensitive axis alignment with respect to enclosure 95*51*38 (mm) Anodized aluminium Engraved on the cover < 220 g < ±5mrad (<±0.29°) Power supply 4.5VDC to 30VDC (sensor can be supplied by USB bus) Consumption < 60mA (single axis) & < 100mA (twin axis) Output signals 2 wires RS485 MOBUS RTU/ USB 2.0/ 4-20mA Signal output Range Analogue output sensitivity Non linearity error Bias calibration error on [-40 ;+85°C] digital output Bias calibration error on [-40 ;+85°C] analogue...