Tail Support StanchionModel 705C & 745b| Model 705C Model 745B The Models 705C and 745B are for use on the Boeing 747 Freighter/Combi and the 747-8F during cargo operations to dampen aircraft movement caused by change in center of gravity and weight. Nose door sill movement is reduced 50-80%. Model 705C is designer for fixed location operations, while Model 745B is a flyaway unit for ULD air transport on a 125 inch x 88 inch pallet. Model 705C & 745B are “Unipod” type units with a tripod support structure. The stanchions are rated at 15 tons and may be pre-loaded with the integral hand pump to any load up to 25,000 pounds. The stanchion load ram is then a solid column at loads up to 25,000 pounds. When the load exceeds the limit, a pressure relief valve opens to a gradual retracting of the load ram. The ram will return to a solid column when the load reduces to approximately 22,500 pounds. This hydraulic dampening effect occurs slowly to restrain aircraft vertical movement. As the aircraft center of gravity shifts forward or weight decreases, the stanchion ram extends with the aircraft until a compressive load is reapplied, thus acting to restrain the aircraft against tipping. Both Malabar models meet or exceed Boeing recommendations. Specify either model for applications requiring Boeing Tool #ME65B16362. Models 705C & 745B are built to withstand harsh environmental conditions, rugged use and to provide many years of continuous service. Our customers are guaranteed a quality product with each purchase and are assured of our continued product support whenever and wherever the need arises. For more information contact: [email protected] 220 W. Los Angeles Avenue • Simi Valley, CA 93065 USA • Tel: 1-805-581-1200 • Fax: 1-805-584-1624 • www.malabar.com

Tail Support StanchionModel 705C & 745b| Malabar Head Stock Attached to Aircraft Models 705C and 745B include a head stock (as shown above) that clamps to the B747 Freighter/Combi and the B747-8F tail ball fitting. The head stock jaws are operated by an integral hydraulic cylinder for opening and closing the jaws around the ball fitting. The head stock jaws travel over center to the closed and lock position to ensure a positive connection even in the event of a loss of hydraulic pressure in the jaw cylinder. The stanchion cylinder assembly is supported by the tripod leg structure for towing and...

Models 705 & 745B Typical Applications: Tail Support for B747 Freighter/Combi and 747-8F Optional Equipment Codes: (Order Separately) AP: Air Pump (705C only) FT: Foam Filled Tires (705C only) SPC: Specified Paint Color Packaging Codes & Options: (Specify with order) -: Domestic Skid EC: Export Crate (Additional Cost) For more information contact: [email protected] 220 W. Los Angeles Avenue • Simi Valley, CA 93065 USA • Tel: 1-805-581-1200 • Fax: 1-805-584-1624 • www.malaba

Tail Support StanchionModel 705C & 745b| Shipping Data: NOTE: Unless otherwise specified, Model 705C is shipped on a wood skid in the knocked down condition. For more information contact: [email protected] 220 W. Los Angeles Avenue • Simi Valley, CA 93065 USA • Tel: 1-805-581-1200 • Fax: 1-805-584-1624 • www.malabar.com