LP3
1Pages

Frequency Converter An easy to use Frequency Converter, with 3kVA of variable Three Phase output The standard unit has three phase output at up to 3kVA and can operate from a European 230V single phase supply. Output frequency can be set by the user to any value between 45Hz and 1000Hz. Output voltage is variable from zero to a maximum in two ranges, 0-135/234V and 0-270/468V. Output current capability is doubled on the lower range. Control of the unit is all touch button interface, with a clean concise LCD screen. The values chosen by the operator are stored by the microprocessor when the for immediate use on future occasion. Values can be adjusted at anytime whilst live online or offline. The output is a pure sine wave, and is fully protected against over current conditions. In addition to the built-in output protection. The LP3 can be supplied with an RS232 remote connector which can be connected to any PC operating on a windows platform allowing full control of the unit remotely. This unit is available in a 19” rack mounting version or a bench unit. Output Capability 45-1000Hz in steps of 1Hz, accuracy +/-1Hz Low Range 0-135/234V (Ph-N/Ph-Ph) 7.4A max High Range 0-270/468V (Ph-N/Ph-Ph) 3.7A max Current ratings are for each phase Overload Capability Overcurrent trip after 1 second, at >110% full load on any phase Admissible Load Power Factor 0.5 lag to 0.5 lead at full load Output Protection Overcurrent, short circuit, overtemperature Better than 5% for 0 - 100% Rated Load Immediate power limiting, at >2kVA on any phase Better than 0.2% for 10% line voltage change Effi ciency Input On/Standby Soft touch push button for control of all functions Alpha - Numeric Display of output settings Input On and Output Ready indicators Sinusoidal, THD better than 5% at full load Better than 1% over 24 hours after 1 hour warm-up Full, by transformer coupling of output Electromagnetic Compatibility CE-marked to European requirements Operating Environment 0 to +40 degrees, 0-90% non-condensing <65dBA ambient noise Storage Environment Size & Weight description, either as a result of continuous product development, or in the event of any errors not detected when this document was last updated. Output Waveform 434mm wide x 510mm deep x 80mm high, 45kg 550mm deep with Handles This specification is for a standard converter. Units with special voltage ranges will change output current capability. Magnus Power. Vision House, 41 Brunel Road. St. Leonards on Sea East Sussex. TN38 9RT Email: magnuspower.sales@akersolutions.com Although the information and recommendations on this document are presented in good faith and believed to be correct, Magnus Power makes no representations or warranties as to the completeness or accuracy of the information. Information is supplied upon the condition that the persons receiving same will make their own determination as to its suitability for their purposes prior to use. in no event will Magnus Power be responsible for damages of any nature whatsoever resulting from the use of or reliance upon information from this datasheet or the products to which the information refers. Magnus Power does not warrant the accuracy or timeliness of the materials on this datasheet and has no liability for any errors or omissions in the materials.