CABIN TECHNICAL SPECIFICATIONS DIMENSIONS INSIDE 1495mm 1722mm 1450mm Length: Width: Height: STRUCTURE AND LAYOUT: Configuration Material: Suspension: Doors: Two seat cabin with driver center positioned on 180° turntable console Lazer cut steel with steel tube reinforced pillars Attached to chassies on hydraulic 4-link suspension Two lockable doors with opening windows. Optional electric operated. SEATING AND CONTROLS Driver seat: Passenger: Switches: Instrument: Com radio: Mirrors: Sunshield: Be-Ge with heating and mechanical or optional pneumatic suspension, safety belt Folding type Located on overhead panel, easily accessible in both seating directions Danfoss multifunction display on turntable console including all instruments and display for optional cameras Pre wired console for three DIN units in cabin roof. Two outside and two inside. Optional outside electric heated and adjustable Curtain type front and rear WINDSCREENS AND WIPERS: Front: Type/certification Wiper Rear: Type/certification Wiper Laminated and tinted safety glass. Optional with heating Single arm wiper with washer Laminated and tinted safety glass. Optional with heating Two arm parallel wipers with washers ELECTRICAL EQUIPMENT: Integrated head lights Roof rack with direction light front and rear Pre wired for extra equipment Reverse warning beeper Horn Cabin interior light Automatic control by Can-bus system and temperature sensors Optional airconditioning integrated for full ACC SURFACE COATINGS: Zirconium preparation Epoxy primer Polyurethan top coating Inside RAL 7024 Outside to customer specification Address Telephone Fax Mail Internet Specification may vary according to requirements and conditions,and are subject to change without notice. www.kalmarmotor.com © Kalmar Motor AB 2011