skynav ILS
2Pages

{{requestButtons}}

Catalog excerpts

skynav ILS - 1

INTELCAN’S N8000 SERIES Instrument Landing System (ILS) exceeds the highest standards for precise radio guidance in the aircraft’s final approach and landing. Whether for Category I, II, or III, the N8000 guarantees signal integrity and comes in single or dual frequency configuration. Intelcan’s team of experts knows that each airport is unique and that each site comes with its specific challenges and complexity. For that, the N8000 has been designed to be simple to operate, easy to maintain and to offer a high degree of configurability. The N8000 is a solid state system, built with the latest technologies, ensuring a long life at low cost. The design relies on DSP and FPGA processing units to monitor all parameters of the transmitted signals in realtime; combined with extensive BITE (Built-in Test Equipment), the system autonomously takes corrective action whenever needed; the outcome is a highly dependable system for safe landing management, and full awareness for your technical staff. The N8000 series offer the following sub systems: The N8100 Localizer, provides horizontal alignment for the aircraft with the runway centerline The N8200 Glide Path, provides vertical alignment and angle of approach The N8300 Marker Beacons to identify particular locations along the approach Key Features Highly reliable systems built to run continuously and fully unattended for continuous service Durability against time and weather to ensure signal accuracy is never compromised Fully compliant with ICAO Annex 10, international RF, electrical, and environmental standards Configurable for CAT I, II or III Antennae with proven performance under extreme environmental conditions. Multiple antenna configuration options depending on site requirements. Localizer and GlidePath available in single or dual frequency modes. Available near field and far field monitors for superior signal integrity monitoring. Full redundancy of critical components and advanced embedded watchdogs ensure 100% system uptime. Enhanced BITE (Built-in Test Equipment) for detailed capture and analysis of system status. RCMS – Remote Control and Monitoring Systems Intelcan offers unparalleled management capabilities without compromising ease of use. RCMS can be easily connected with multiple types of communication media: wireless, fiber optic cable and traditional telephone cable. The RCMS presents critical information and control at your fingertips, in real time: Remote Control Unit (RCU) for technical operators Remote Status Unit (RSU) for the air traffic control room Remote Monitoring and Maintenance application (RMM) for maintenance personnel. The RMM uses an open-architecture software with an intuitive interface, allowing for fast localization of problems, and providing the user with suggested corrective actions. Its primary features include: At-a-glance view of the whole ILS system and its status Centralized monitoring of up to 100 systems simultaneously and in real-time Continuous monitoring for alarms and warnings Alarm reporting to field technicians via email or SMS to ensure faults in the system are received instantly by the appropriate personnel Continuous status logging and periodic reports for performance measurements and preventive maintenance Full remote control Remote configuration and software upgrade Compare multiple systems side-by-side Save configuration as a file, load configuration from file Multiple users can access in parallel Multiple access levels ensure the right users have the right privileges Support remote web browser monitoring (password p

Open the catalog to page 1
skynav ILS - 2

SKYNAV ILS N8000 series Glide Path Specifications INTERFACES Ethernet (LAN) RS-232 (Serial) Configurable Inputs/Outputs Dual freq. with 8 KHz diff. 50kHz 108.0 MHz to 111.975 MHz 10/100 Mbps, full duplex, RJ45 connector EIA-232 DTE, DB9 male 8 digital inputs, 8 analog inputs 10/100 Mbps, full duplex, RJ45 connector EIA-232 DTE, DB9 male 8 digital inputs, 8 analog inputs 110 to 230 VAC 50/60 Hz < 500 W for single transmitter Mini 4 hours of autonomy -50 to 70°C (outdoor equip.) -10 to 50°C (indoor equip.) -50 to 70°C 0% to 95% RH -50 to 70°C (outdoor equip.) -10 to 50°C (indoor equip.) -50...

Open the catalog to page 2

All INTELCAN catalogs and technical brochures

  1. SKYCOM AMHS

    1 Pages

  2. skysurv PSR

    2 Pages