SEPS MODELS The ERGL is available in two SEPS models: Standard and Wireless. With the standard SEPS, the unit will activate automatically between dawn and dusk with pre-set illumination. The wirelessly controlled SEPS allows the unit to be activated remotely via a handheld controller. PRODUCT APPLICATION The Solar Elevated Runway Guard Light (ERGL) provides a distinctive warning to pilots that they are approaching a runway holding position and are about to enter an active runway. The ERGL has a high intensity LED light source and is powered by our industry leading solar engine power supply (SEPS). The ERGL fixture is fabricated from corrosion-resistant materials and all exterior surfaces are painted aviation yellow for added protection and visibility. Includes high-strength ERGL base plate. The two ERGL light sources are surrounded by a black face plate and independent visors to reduce the amount of incident sunlight, thereby maximizing the contrast during the LED ON/OFF cycle. FEATURES • Provides 24-hour unidirectional marking at runway and taxiway intersections • Installs in minutes and can be relocated just as quickly • Includes LED lights, frangible column and tether • Fixture flash-rate is controlled from an intelligent lighting control system module located in the SEPS; alternating flashes, 45-50 per minute • Can be aimed both vertically and horizontally and has an adjustable Light Beam: 0° to 20° vertically; ±20° horizontally • Significant reduction of maintenance costs and relampingbexpenses through long-lasting LED technology - average LED life of 56,000 hours under high-intensity conditions and more than 100,000 hours under actual operating conditions • Engineered for reliable performance, the Energy Management System (EMS) monitors and adapts brightness to environmental conditions for consistent operation and long life under tough conditions • Autonomy (operation without solar charging) 7+ days -scalable to meet requirements up to 40 days INSTALLATION ERGL systems are typically installed in pairs with one unit on either side of the taxiway holding position.The ERGL should be installed according to FAA AC 150/5340-30.The SEPS should be installed on a level concrete pad within 20 feet of the ERGL. For a temporary application, the wiring between the SEPS and the ERGL can be above ground. Both the ERGL and SEPS contain side conduits for cabling access. • Battery life: 5+ years Astronics DME

OPERATING CONDITIONS SOLAR LIGHTS - 7.2 Solar Elevated Runway Guard Light

SOLAR LIGHTS - 7.2 Solar Elevated Runway Guard Light *Note: height and width dimensions will vary as angle of unit is increased to 55° tilt max 6830 NW 16th Terrace • Ft. Lauderdale, FL 33309 USA Phone: 1.954.975.2100 • Fax: 1.954.979.3313 E-mail: [email protected] • www.astronics.com Actual product specifications may have changed since the printing of this brochure. Brochure specifications are not binding. Confirm current specifications at time of order Solar Elevated Runway Guard Light 032116