tracked sliding gate BENEFITS & FEATURES • The trackwork is cast into the concrete foundation which is poured in two stages • The track is bolted down to the first pour concrete and the second pour brings the level up to finished road level • The track is normally 5mm below finished road level • electronic control motor drive unit, 100% duty rated OPERATING SPEED • Typical operating speeds of 225-500mm/second* (depending on configuration) OPTIONS • Disengaging box - manual override • I00/200mm Traffic Light System • Can be interfaced to any access control systems SAFETY • vehicle detector loops • Safety photocell beams and ultra-sonic sensors • Safety edges • Signage, audible alarms and flashing beacons CIVIL REQUIREMENTS Gate Leaf foundation L: 400mm plus Runback length W: 1000mm D: 300mm Receptor post foundation L: 600mm W: 1000mm D: 300mm Note: Power and control wiring ducts may be required ELECTRICAL REQUIREMENTS • Single and Three Phase Supply available extra requirement • Minimum length of runback track: For gate apertures of 8m Runback = Aperture x 1.5 Runback For gate apertures of 8m+ Please contact Technical Sales Department on +44 1293 422800 • Standard height: 2400mm, Max height 5000mm (depending on width of gate) • Full Welded Construction Sliding Tracked Gates, also known as ‘Taxiway Gates’ at Airports or military sites, are designed to run on a track installed in the roadway and are able to secure wide apertures up to 35m. • Choice of infills including seurity weldmesh, bar and weldmesh, sheet, decorative & wood • Bespoke manufacturing Applications: Large Sliding Gates, the perfect solution for Airport Taxiway Gates