Mounting Port Instructions:
- Drill #3 (0.213 inches) x 0.360 inches deep
- Tap 1/4-28 UNF-2B x 0.250 inches deep
- Tolerance: .XXX±.020 inch [0.51 mm]
- Use 1/4-28 x 1.00 long hex head captive bolt
- Connector: 10SL-4P, Hermetic

Specifications:
Model: 3059A LIVM Accelerometer
Physical:
- Weight: 74 grams
- Size (L x W x H): 1.73 x 0.74 x 0.85 inches
- Mounting Provision: Thru hole, captive 1/4-28 bolt
- Electrical Connector: 2-pin military 10SL-4P, hermetic
- Material: 300 series stainless steel
- Element Style: Ceramic planar shear
Performance:
- Sensitivity: 100 mV/G ± 5%
- Range for ± 5 volts out: ±50 G
- Frequency Response: 0.3 - 8,000 Hz ± 3 dB
- Mounted Resonant Frequency: 21 kHz
- Equivalent Electrical Noise Floor: 0.0006 G RMS
- Amplitude Non-Linearity: 2.0% F.S., max.
- Transverse Sensitivity: 5% max.
- Strain Sensitivity: 0.001 G's per microstrain @ 250/μs
Environmental:
- Maximum Vibration: 350 G's, RMS
- Maximum Shock: 3000 G's, peak
- Temperature Range: -60 to +250 °F
- Environmental Seal: Glass to metal/welded, hermetic
Electrical:
- Compliance (Supply) Voltage Range: +20 to +30 VDC
- Excitation Current Range: 2 to 20 mA
- Output Impedance: 200 ohms nominal
- Output Bias Voltage: 11 to 13 VDC
- Discharge Time Constant: 0.5 to 1.2 sec.
- Output Signal Polarity: Positive going for acceleration toward top
- Power/Signal Ground to Case Isolation: 10 megohms min.
Supplied Accessories:
- None
Notes:
- Sensitivity measured at 100 Hz, 1 G RMS. A calibration certificate traceable to NIST is supplied with each instrument.
- The use of Dytran LIVM current source power units is recommended. Do not connect this instrument to a source of DC voltage without current limiting protection, 20 mA max. Doing so will destroy the internal amplifier and void the warranty.