OmniDeck™ with WashBar®– 5000 Series
11Pages

{{requestButtons}}

Catalog excerpts

OmniDeck™ with WashBar®– 5000 Series - 1

OmniDeck™ with WashBar – 5000 Series ® • Basin(s) and Deck are constructed of Terreon® or Terreon®RE Solid Surface Material • Decks are Pre-fabricated; Shipped Complete to the Job Site • Custom and Standard Sizes Available • Optional Coved Backsplash and Integral Front Apron Eliminate Caulk Lines • Integral bowl option creates seamless look • All-in-One chrome-plated cast alloy WashBar® includes touch-free soap, water and dryer Model LD-5010-2 • WashBar technology intuitively guides user and eliminates simultaneous activations • Basin and drain engineered to evacuate water and dissipate air flow WashBar All-in-One chrome-plated cast alloy WashBar includes touch-free soap, water and hand Specifications The OmniDeck Model LD-5010 can accommodate one or more users. Model LD-5010 dryer. Load tested to 500 pounds, the WashBar is secured to the basin with two antiOmniDeck with WashBar features a Terreon solid surface deck with undermount basin. rotational shanks. Blue LED lights help guide the user to the WashBar, indicating the The OmniDeck with WashBar comes equipped with single piece All-in-One WashBar, three functions. The LED light will change from blue to green to signify that the function allowing users to access soap, water and a hand dryer without leaving the hand washing is in use. Each function is easily identified by the corresponding icon on the WashBar's station. Optional aprons, splashes, mounting brackets and single-station access panels top surface. To aid in a smooth, controlled hand-washing and drying operation, sensors are programmed to eliminate simultaneous activations of nearby functions. WashBar are also available to round out the total package. sensors are not affected by varying skin tones or darkness. Smart technology allows the facility manager or maintenance staff to clean and configure with ease. Construction Deck Constructed of ½" thick Terreon, a densified solid surface material composed of bio-based resin or TerreonRE, a densified solid surface material composed of a bio-based resin and preconsumer recycled granules. Terreon and TerreonRE are resistant to chemicals, stains, burns and impact. Surface damage can be easily repaired with everyday cleansers or fine grit abrasives. Terreon and TerreonRE are GREENGUARD® certified as low-emitting materials. Cleaning Mode WashBar has an activation feature to put the unit into cleaning mode to allow for easy cleaning of the WashBar and basin without activating the functions. Basin The basin model WB-TR1 has been designed to direct water to a trench drain and features a 300 series stainless steel drain cap. The basin and drain cap work together to evacuate water and dissipate airflow to prevent splashing on the user or floor. The basin is constructed of Terreon solid surface and is available in all Terreon colors. Internal basin dimensions are 11-1/2" x 21-5/8" x 8-1/8". Soap Dispenser The soap dispenser is located on the left side of the WashBar. This eliminates any soap from dripping on counters or onto the floor, minimizing slip hazards and allows for easy cleaning. Choose between a foam or a liquid soap dispenser, which are compatible with most bulk soaps. Soap system accommodates a 1 gallon container to reduce the number of soap replacements. When the LED light above the soap function turns to a solid red, simply check the level and replace the soap container with a full container if necessary. The soap system includes an adapter to fit many 1 gallon cylindrical soap containers available on the market. Please visit https://www.bradleycorp.com/ maintenance/soap-dispeners for soap recommendations. Configuration Mode WashBar also has a configuration mode to identify how many cycles are on the soap, faucet and dryer. Mode also allows for dryer speed and sound adjustment at low, medium and high levels. Faucet Faucet is located in the center of the WashBar and has a spray angle of approximately 17 degrees off the vertical. Choose either a 0.5 gpm or 0.35 gpm PCA rubber tip aerator. Maximum run time is 11 seconds. The 0.5 gpm/1.90 Lpm option is the equivalent to 0.9 gpc/0.35 Lpc and the 0.35 gpm/1.33 Lpm option is the equivalent to 0.07 gpc/0.24 Lpc. Automatic 5 second purge within 24 hours of the last use. Recommended operating range is 20-80 psi. Verify all rough-in dimensions prior to installation. Consult local and national codes. Conformity and compliance to local and national codes is the responsibility of the installer. Page 1 of 11 8/22/2019 This information is subject to change without notice. Bradley_Sink_OmniDeck_LD-5010

Open the catalog to page 1
OmniDeck™ with WashBar®– 5000 Series - 2

OmniDeck™ with WashBar – 5000 Series ® Dryer The hand dryer is located on the right side of the WashBar, allowing users to dry their hands immediately after washing. This virtually eliminates excess water on the floor. The dryer motor provides warm air at three speeds, high-medium-low, which can be field adjusted by placing the WashBar into configuration mode. The single sided dryer will dry hands in approximately 15 seconds depending on user preference. The decibel range with hands in air stream is 76 dB (high speed) to 64 dB (low speed). Code Compliance and Certifications Standards...

Open the catalog to page 2
OmniDeck™ with WashBar®– 5000 Series - 3

LD-5010OmniDeck™ with WashBar®- 5000 SeriesStandard Dimensions - 1-Person (mm) Verify all rough-in dimensions prior to installation. Consult local and national codes. Conformity and compliance to local and national codes is the responsibility of the installer. © 2019 Bradley Page 3 of 11 8/22/2019 P.O. Box 309, Menomonee Falls, WI 53052-0309 This information is subject to change without notice. 800 BRADLEY (800 272 3539) +1 262 251 6000

Open the catalog to page 3
OmniDeck™ with WashBar®– 5000 Series - 4

OmniDeck™ with WashBar – 5000 Series ® LD-5010 Dimensions (Side View) Surface mount brackets shown. Deck depth must be 20-1/2" minimum for ADA, Enhanced Reach depth is 20-1/2" Verify all rough-in dimensions prior to installation. Consult local and national codes. Conformity and compliance to local and national codes is the responsibility of the installer. Page 4 of 11 8/22/2019 This information is subject to change without notice. Bradley_Sink_OmniDeck_LD-5010 Deck depth must be 20-1/2" minimum for ADA, Enhanced Reach depth is 20-1/2"

Open the catalog to page 4

All Bradley Corporation catalogs and technical brochures

  1. CLE SERIES

    8 Pages

  2. HL Series

    8 Pages