Compliance with Standards A Ordering Information ICAO: Annex 14, Volumn 1 FAA: AC 150/5345-46 NATO: STANAG 3316 CAAC: GB-T 7256-2005 TAE-12 12-inch Runway Threshold/End Light Runway threshold/end • Using new casting process has good mechanical properties. • Use integral patent prism structure, excellence performance of optical. • Smooth flat for light emitting with high efficiency, no deposits of rain above the prism. • Serious design, use different kinds of flitter and lamps could meet the requirements of several different types of lights. • The same series of lamp parts are easily interchangeable; effectively reduce the cost of production. • Smooth lamp cover without sharp edges, better protection of aircraft tire. • Large area of the radiating ribs around the whole outer surface has good heat dissipation performance of the light fixture. • Shock-proof design for integral Bulb holder can effectively prolong the service life of bulb. • Reasonable parts positioning design, no need calibration for replacing the prism, optical components such as filters or bulb. • Special process of anodic oxidation Lighting surface using a, wear resistance, corrosion resistance. • Lights equipped with special remove tool, convenience installation and replacement. Beam Direction L=fixture on the left side R=fixture on the right side S=Straight | Runway Threshold | © Lamp Power 315 = 3x105W 210 = 2x105W GR = one side is green, another side is red - * Detail information should be provided if any special requirments. Accessories should be ordered separately. Fig 1. On 12” shallow base Fig 2. On 12” deep base *The depth of deep base is 550 mm.