als ••••••#••*••• AIRFIELD LIGHTING SYSTEMS UK LTD Compliance • ICAO Annex XIV, Vol. I, Par. 5.3.22, Configuration A, Appendix 2, Fig. A2.25 High Intensity • EASA CS-ADR-DNS BOOK 1 One of the installations required for prevention of runway incursions is the Runway Guard Lights (RGL), also referred to as "Wig-Wag". These should, under certain conditions, be installed on every taxiway connected to the runway as the last resort to remind a flight crew that they must have a clearance to continue before entering an active runway. The elevated Runway Guard Light WAGGY is the answer to these problems. Based on a new generation of LEDs and a revolutionary design both in size and light output, WAGGY is a real "attention getter", thanks also to its specific flashing pattern exhibiting crisp ON and OFF status. Outstanding Photometric performances Life expectancy of LEDs over 60.000 hours eliminates the need for costly re-lamping operations Low Power Consumption: 20 Watt only Natural air Cooling Model 6.6A: powered by series lighting circuit through power converter with 5 steps brilliancy Model 120/230VAC: powered from mains AC parallel lighting circuit; equipped with photocell to control lamp intensity. Solar Power Pack Flash Rate: Alternating flashes, 45-50 per minute Main Beam Coverage- +/- 8° both vertical and horizontal Adjustable Light Beam: 0°, 5°, 10°, 15° vertically through adjustable slip fitter. Mounting on standard 2" O.D. Breakable coupling or Low Profile Frangible Bracket Tether preventing the RGL from being blown in case of impact Made of corrosion resistant materials Aviation Yellow powder coating Environmental Operating Conditions Temperature: -30°C to +55°C OPTIONAL As an additional safety option, the WAGGY can be equipped with a fault monitoring module compliant with FAA requirements Airfield Lighting Systems UK Ltd. - Aviation House, Russell Gardens, Wickford, Essex, SSI 1 8BF, UK www.alsukltd.co.uk Phone : +44 (0) 1702

als ••••••#••*••• AIRFIELD LIGHTING SYSTEMS UK LTD Low Profile Frangible Bracket The WAGGY has been engineered taking into consideration the challenge of the high light intensity required, in a wide angle distribution, whilst maintaining the operating temperature of the light head to a minimum to guarantee the life expectancy of the LEDs. The power converter includes the following features: • Monitoring of the temperature of the LEDs with automatic correction of the forward current to maintain the correct color of the beam within the limit of ICAO requirements. • Control of the flashing mode....