Catalogs >
AES AIRFIELD EQUIPMENT & SERVICES SL >
Inset LED Runway Guard Light

Inset LED Runway Guard Light
4Pages

Catalog excerpts

Airfield Equipment and Services SL Compliance         ICAO Annex 14 , FAA AC 150/5345-46, EB 67 D IEC61827 EASA CS-ADR-DSN.M.710 & 715 STANAG 3316 CAAC GB-T 7256-2005 AENA DIN/OSEYN/PPT/018-02/09 Uses • The IRGS-08-LED-E is a Guard Light suitable for applications on runway system operating in Cat I to III conditions. 8” outer diameter 6 mm height above surface Dust and Water tight Useful Lamp Life (LED) > 50.000h Nominal Current: 6.6A (2.2A available upon request) Power consumption (at 6.6A): 15W per side Power Factor 0.95 at nominal current Temperature: - 55ºC to + 55ºC Advanced Power Adaptor electronics with Integrated 5 steps Active Fail Open System Self Rearming Fail Open System no additional intervention required after repair of a failure. Fully dimmable as per EB67D Built-in surge protection Compatible with existing AGL circuits Efficient control of the operating temperature of the LEDs increasing life expectancy and avoiding any colour shift. Upper surface without sharp edges, reducing the risk of damage to aircraft tires Finish • Outer Surface with wear & corrosion resistant treatment. • High-precision machining ensuring overall precision and excellent quality. • Stainless steel hardware. Electrical Supply 6.6 A, through a 150 W isolating transformer.

Open the catalog to page 1

Airfield Equipment and Services SL Components Inset Runway Guard Light Photometric Characteristics

Open the catalog to page 2

Airfield Equipment and Services SL Grounding The light is equipped with a grounding point as shown on the figure. Adaptor Ring An adaptor ring in forged aluminium is available for mounting of the light on a 12” base Lifting Handle A lifting handle in aluminium has been designed for easy installation and removing of the light on its base

Open the catalog to page 3