HTG-240
1 / 6Pages

resoltech * resoltech HTG-240 Hardener HTG-245 High TG Structural Infusion Epoxy System - Tg >220 °C - Low viscosity and excellent wetting properties - High thermomechanical performances

RESOLTECH HTG-240 / HTG-245 resin is very high TG resin system specially formulated for the manufacture of tooling and large structural composites parts requiring TG's and service temperature up to 220 °C. Due to its low viscosity, high wetting properties and excellent air release, it is suitable for the manufacture of structures and composite parts by infusion, injection moulding. HTG-240 / HTG-245 system contains no CMR components or VOC to reduce user exposure. The stable low viscosity vs temperature makes of the HTG-240 a prime choice for infusion process. However, this system is not...

Mix : Opalescent yellow liquid HTG-245: Neutral transparent liquid ym Visual aspect I HTG-240: Opalescent yellow liquid * Gel time measurements realized with Rheotech" ** Gel time on film measurement realized on rheometer : gap 1 mm, shear rate = 1 s-1, 0 = 35 mm

HTG-240 mixed viscosity evolution at 23 °C In order to obtain the maximum thermo-mechanical properties, it is necessary to respect the recommended curing cycle. The table below shows the glass transition temperatures (DMA & DSC) according to different curing cycles. Tg measured by DMA, 3 °C/min Te measured by DSC, 40 °C/min, inflexion point Post-curing cycles previously presented were chosen in order to reach the maximum potential of each systems. Depending on parts size, oven performance and hardener used, shorter post-curing cycles could lead to fully cured parts. Please contact our...

Flexion properties on pure resin according to ISO 178

HEALTH & SAFETY - Plastic jerrycan kit of 1kg + 0.24kg - Plastic jerrycan kit of 4.2kg + 1kg - Plastic drum kit of 21kg + 5kg - Metal drum kit of 200kg + 2 x 24kg - IBC kit of 812kg + 195kg TRANSPORT & STORAGE Keep containers sealed and away from heat and cold preferably between 10 °C and 30 °C in a well ventilated area. Our products are guaranteed in their original packaging (check expiry date on the label). Skin contact must be avoided by wearing protective nitrile gloves & overalls or other protective clothing. Eye protection should be worn to avoid risk of resin, hardener, solvent or...