AN-3000Aic(A6)
1 / 6Seiten

AN-3000A IC（A6） INDUSTRIAL HEADSET （FOR ICOM A6 A

HEADSET OPERATION 1. Rotate the flexible boom overhead to wear the microphone on either the right or left side of the head. 2. Rotate the headset volume control (on the side of the headset opposite the microphone boom) fully counter-clockwise to the minimum position. before the headset plug is inserted into the aircraft or intercom 3. With the headband resting securely on the top of the head, check that the earseal are centered over the ears. 4. For best noise cancellation, position the microphone 0-6 mm from your lips . 5. Insert the headset plug into the two way radios (ICOM A6 A24) jack....

Specifications Noise Reduction Ratings（NRR） 24dB ： Headphone Type: Dynamic （50） Frequency Response: 100Hz to 8 kHz Sensitivity: 95±5 dB SPL (1 kHz, 1 mW input per earcup side) full volume on ear simulator 150 ohms (300 ohms each; wired in parallel) Rate Input: Microphone and Amplifier: Element Type: Noise-canceling Amplified Dynamic Microphone Frequency Response: 150Hz to 8kHz Operating Voltage (supplied by the two way radios ): at 1 kHz with 10 Vdc 150 ohms AC load) Temperature: Operating: - 25 to 70°C Storage: -50 to 75°C Cordage: AN-3000AIC（A6） Straight cord from headset to molded plug,...

EXPLODED VIEW AND DISASSEMBLY INSTRUCTIONS ： PARTS LIST MODEL AN-3000AIC(A6)

PARTS LIST RETAINING RING DOME STOP , STAINLESS STEEL RIGHT EARCUP EARPHONE ASSEMBLY 50 300 OHMS MICROPHONE PLUG CORD FLEXIBLE BOOM ASSEMBLY AMPLIFIED DYNAMIC MICROPHONE MICROPHONE WINDSCREEN STRAIN RELIEF COMM CORD , STRAIGHT OVERHEAD CORD HEADBAND , STAINLESS STEEL HEADBAND CUSHION OVERHEAD CORD CLAMP LEFT EARCUP

HEADSET SCHEMATIC DIAGRAM BLACK PUSH ON/OFF