Temperature & Humidity Controller
1Pages

HUMIDITY CONTROLLERS AND TRANSMITTERS RH/Temperature Controller and Probe • Included duct probe may be up to 1,000 feet from the controller • Stainless steel probe (10” long, .75” diameter) • State-of-the-art thin film polymer sensor • Recorder outputs • Two 5 Amp, 250 VAC SPDT relays for setpoint output • 1/8 DIN metal enclosure with panel mounting bracket • Digital display of setpoints, bandwidths, and measured values The CSP Series measures and displays Relative Humidity (RH) and Temperature. It is also a setpoint controller. The controller output consists of two-5 Amp 250 VAC SPDT relays, one for RH and one for Temperature. The setpoint and dead band controls are independent of each other, which makes setting these parameters fast and simple. The CSP also has recorder outputs for RH and Temperature. The included probe can be duct or wall mounted up to 1,000 feet from the controller. Relative Humidity* 3 % RH to 95 % RH range at ±2 % accuracy, 1 % display resolution. Temperature compensated -10 °F to +175 °F. Temperature* 0 °F to 180 °F range at ±1° accuracy, 1° resolution (0 °C to 85 °C, ±.6 °C accuracy for °C version) Response Time* Under 20 seconds Controls Setpoints: 0 % RH to 100 % RH, 0 °F to 180 °F. Dead bands: to ±50 % RH, to ±50 °F (±40 °C) - all digitally displayed Recorder Outputs 10 mV/% RH and 10 mV/°F (10 mV/°C) Controller Outputs Dual SPDT relays, 5 amp/250 VAC contact rating Display 0.56 in high-brightness digits Off-scale indication for open wires Relay "ON" indicators Input Power 115 VAC ±15 % 50/60 Hz, 5 watts maximum. 230 VAC model available * Specifications with included TEGAM RDP-20C Probe TEGAM RDP-20 stainless steel probe, 10 in. long, .75 in. diameter. Mounting Panel cutout 45 mm (1.77 in) x 92 mm (3.62 in). Mounting bracket adjusts to 3/8 in. (9.5 mm) maximum panel Enclosure 1/8 DIN metal enclosure with panel mounting bracket Weight Controller: 538 g (19 oz ) Probe: 198 g (7 oz) with flange Connections Screw terminals, 14 AWG maximum, 10 amp/250 V. Probe supplied with 4 pin mating connector for 26 to 18 AWG wires ORDERING INFORMATION RH/TEMP Controller and Probe (115 VAC Power) Order Model: CSP-F1 (°F) Order Model: CSP-C1 (°C) RH/TEMP Controller and Probe (230 VAC Power) Order Model: CSP-F2 (°F) Order Model: CSP-C2 (°C) Included Accessories Manual P/N CSP-F1-900-01 P/N RDP-20-901-01 Optional Accessories RH Calibration Kit P/N RH-CAL Allows fast calibration of all TEGAM humidity controllers and transmitters. Calibration salts for 11 % and 75 % RH points are good for at least two years.The kit contains the following: • (2) Bottles containing 1 oz (28 gm) each of ACS’ reagent quality, lithium chloride (11.3 % RH) salt and sodium chloride (75.3 % RH) salt. • (2) Fitting caps to accommodate all TEGAM humidity controllers and transmitters. • (1) liquid dropper • Set of instructions • Case Z540 Compliant Calibration with Certificate Prices and specifications subject to change without