ME1
4Pages

Static Frequency Converter Three Phase Output 3.2kW - 32kW 1:1 The ME1 series of Static Frequency Converters consists of a wide range of single and three phase input systems with a single phase output. Custom built systems to meet specific requirements are our speciality, the ME1’s modular microprocessor based design makes it incredibly flexible and thus easy to meet almost any build requirement. System Operation The Power Factor Corrected rectifier converts the single or three phase mains supply into DC, the PWM inverter then switches the DC back to AC at the desired frequency and voltage, the output transformer provides Galvanic Isolation which isolates the input and output from each other. Specifications Enclosure High quality steel enclosure finished in RAL7032 powder coating Cable entry is at the rear for NA, NB and NC enclosures and top cable entry on the SD enclosure, all systems have removable gland/back plates to allow for simple installation IP rating for standard enclosures is IP21 (higher IP ratings available) Castors are provided on systems supplied in NA, NB and NC enclosures to allow good manoeuvrability during installation. A Plinth on systems supplied in SD enclosures allows good manoeuvrability with forklift or pallet truck during installation, cabinets are sized to fit through standard doors. Plinth colour RAL7011 The SD enclosure is supplied with a Key locked front door with the option of double key locks available for units with restricted security access System Sizes subject to change without notice Rectifier Power Factor Corrected, microprocessor controlled rectifier, this means that the current drawn from the mains is in phase with the voltage (0.99pF @ full load). In simple terms it means that you pay less money on your electric bill to achieve the same result as a non-power factor corrected rectifier, it also means less distortion of your mains supply. Single and three phase input available Protection against DC over-voltage, input mains low and mains surges e.g. Surges caused by lightning. Battery charging facility for systems with optional battery backup High Frequency microprocessor controlled pulse width modulation (PWM) IGBT inverter High quality sinewave output Galvanic isolation with grounded neutral High efficiency Reliable, proven design Remote Monitoring circuits Volt free contacts 200 Alarm records, optional printer is available for hardcopy printout. Consists of 4 x 20 character LCD Dot-matrix with five indicating lights (LED’s), ten scrolling / command buttons and audible alarm which sounds whene

LCD Digital Inverter: Volts AC / Amps / KVA / % Load / Frequency Meter readings Rectifier: Volts AC / Frequency Environment: Ambient Temperature General: Time / Date LCD Scrolling Rectifier Mains Fail Inverter Under-voltage Inverter IGBT saturation fault Inverter Peak current fault Power Supply fault System and Installation considerations Room ventilation Adequate ventilation should be provided to disperse any heat dissipated by the unit. The system will generate a small amount of heat during standby operation but as load is added a greater amount of heat will be generated, as guide, lOOWof...

Optional Factory Fitted Features Internally fi tted options Built in distribution: Single or double pole output circuit breakers can be fitted internally to eliminate the need for an external distribution board. Maximum number of outlets is 10 for single pole and 5 for double pole Printer: An impact printer is available for hardcopy printout of Datalogger RS232 Port: For remote monitoring Software via RS232 SNMP Adapter: For remote monitoring of system via LAN AC output Earth Leakage protection: Can be set to 30/100/300mA depending on application Battery backup (SFC + UPS): Valve Regulated...

MAGNUS POWER Magnus Power Vision House, 41 Brunei Road Global Power Supply Specialists Churchfields Industrial Estate Tel: +44(0)1424 856 172 Email: magnuspower.sales@akersolutions.com