LF1-400
1Pages

Frequency Converter 115/200V 400Hz Single Phase output, at up to 1kVA A transformer ensures full isolation between the output voltage and the incoming supply and the output neutral may be earthed externally if required. The unit is fully protected against overcurrent and overtemperature conditions. Input power and output cable supplied. This unit is normally supplied as a free standing bench top unit; but the LF1 can also be built in a rack mount configuration if required at no extra cost. A support shelf or bracket would be required when the rack mounting option is specified: these are not supplied with the unit, as their dimensions will depend on the arrangement of the cabinet or rack. Input Requirement 115 or 230V single phase, +10% / - 6%, 45 – 66Hz with automatic selection of input voltage Output Capability 115V 400Hz +/- 1Hz, at up to 1kVA (8.7A max) Overcurrent trip at >1200VA Short circuit and overtemperature protection Load Power Factor 0.5 lag to 0.5 lead at full load With linear load, line regulation +/- 1%, load regulation +/- 1% THD better than 5% and full load efficiency >80% Controls, Indications & Connections Output voltage and output current analogue meters Overcurrent and overtemperature indicators IEC inlet connector, twist lock output connector Input and output cable supplied Operating Environment Size & Weight 440 wide x 370 deep x 89 high (2u in 19 Inch rack) <10kg Magnus Power. Vision House, 41 Brunel Road. Churchfields Ind. Est. St. Leonards on Sea. East Susex. TN38 9RT Although the information and recommendations on this document are presented in good faith and believed to be correct, Magnus Power makes no representations or warranties as to the completeness or accuracy of the information. Information is supplied upon the condition that the persons receiving same will make their own determination as to its suitability for their purposes prior to use. in no event will Magnus Power be responsible for damages of any nature whatsoever resulting from the use of or reliance upon information from this datasheet or the products to which the information refers. Magnus Power does not warrant the accuracy or timeliness of the materials on this datasheet and has no liability for any errors or omissions in the materials. Email : magnuspower.sales@akersolutions.com www.magnuspower.