100 LPM Diesel Dispensing Skid Unit With Micro Filter For Diesel
9Pages

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel Flightline Support Limited 49 Brize Norton Road, Minster Lovell, W itney, Oxon OX29 OSG www.flightline-support.co.uk Tel +44 (0) 1993 776564 Fax +44 (0) 1993 778953 Job Number FSL8561 See web site for standard terms and conditions

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel SPECIFICATION FOR A DIESEL PUMPING MODULE 100Ltr / min (Product Diesel) Suction fitting 4” male cam-lock with cap fitted to input of the dispensing skid complete with cap. 3” Renus ball valve for input isolation of skid from tank and suction hose. Input, 3” in-line strainer with removable stainless steel mesh (1000 microns) Hatz diesel key start engine, close coupled to a cast centrifugal pump fitted with a mechanical seal. Output Filtration, Hydac inline Micro filter (3 microns)....

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel SKID BASE • • Steel / Aluminium framework with provision for forklift lifting. Provision for hose storage PIPE WORK / VALVES • All rigid pipe work to be manufactured from 10 or greater stainless steel.All valves are stainless steel ball with PTFE seals • All sample lines will be constructed from stainless steel. SKID ASSY • All skids are tested with Diesel at Flightline Support prior to shipment. New filter elements will be fitted and certification issued. BONDING REEL See web site for...

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel See web site for standard terms and conditions

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel General System Information • • • Pump priming point Ensure the plug is replaced after priming before starting the engine. Do not run the motor without fuel in the pump for more then 5 minutes. Pump drain point. Engine oil fill point. Engine oil dipstick. Check engine oil weekly. See web site for standard terms and

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel Filter clogging indicator. To replace micro filter un-screw filter bowl. Please note the filter will be full of diesel. After changing the filter tighten back up. At the top of the filter is an O”ring seal, ensure this is located. Earth bonding point. Ensure the pumping unit is earthed on site. Hose isolation valve shown in the open position. The valve provided is lockable. 3” Renus valve used to isolate the fuel supply from the pumping unit. Valve shown in the open position.

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel This picture shows the input filter. To check the input filter close the input valve and open the bottom of the filter bowl. Please note the input filter will be full of fuel. With the base removed pull out the filter. Engine speed lever shown in the slowest position. Engine speed lever shown in the fasted position – Pump operation position. ZVA slimline fitted with GPI meter. See web site for standard terms and

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel Press button to switch meter on. Hold button in to zero. 4” Cam-lock for fuel connection. Expansion tank drain valve. Shown in the open position. Insert key – push in and turn to start. See web site for standard terms and

CUSTOMER: Stock SPECIFICATION NO: 414 Web SUBJECT: 100 lpm Diesel pumping skid unit for dispensing Diesel Press red button in and hold until the engine stops. Manual pull start – follow instruction mounted on top of the engine. See web site for standard terms and conditi